Return to Full Site  | View in Desktop Mode

General Supplemental Specifications

The following items were approved at the SUDAS Board of Directors meeting on May 12, 2017. The printed revisions will be distributed in the fall.

  • Qualification of bidders (various): Deleting bidder prequalification requirements to reflect changes to Iowa law.
  • Trench stabilization materials (Section 3010, 2.05): Adding a standard gradation option (Iowa DOT Gradation No. 13).
  • Welder certification (Section 3020, 2.02, B, 1): Revising to align with Iowa DOT changes in welder certification by an American Welding Society accredited facility.
  • PVC water main pipe (Section 5010, 2.01, A): Deleted references to AWWA C905 due to combining of AWWA C900 and C905.
  • Use of fly ash and slag (Section 7010, 2.02, C): Remove the restriction for use of fly ash and slag only with ready mix concrete.
  • Laser guided screed and concrete pumping (Section 7010, 3.01, B & C and 3.02, F): Adding to the specifications to allow the use of laser guided screeds and concrete pumping.
  • PCC overlay pavement (Sections 7010 and 7011): New section for PCC overlays projects.
  • HMA overlay pavement (Sections 7020 and 7021): New section for HMA overlays projects.
  • Sidewalk consolidation (Section 7030, 3.04, B): Clarify that sidewalk thickness less than 5 inches do not require use of a vibrator.
  • Form setting and testing (Section 7030, 3.04 and 3.08): Adding criteria for when the Engineer would check form work prior to concrete placement; also adding requirements for testing.
  • Pavement rehabilitation (Section 7040): Updating information on partial depth patches and added a section on dowel bar retrofit for PCC pavements.
  • Temporary traffic control (Section 8030): New section to provide standard temporary traffic control layouts.
  • Bonded fiber matrix (Section 9010, 2.07): Removing some of the physical requirements for hydraulic mulch so approval is based on performance and to align with the DOT.

Page revised: June 5, 2017